Product categories

Made in China, Shengyang FRP


Tel: 0536-4971568

Fax: 0536-4832568

Q Q541725060

Manager: Yin Huibin

Mobile: 13583651568

Address: No. 388, FRP Industrial Park, 2km south of Anqiu toll station, Weifang, Shandong, China



What are the installation points of FRP tank

FRP hydrochloric acid tank is what we usually call FRP tank. It has the characteristics of high strength, simple maintenance and long service life. But if you want to achieve the use effect of FRP tank, you need to do a good job of its installation. Here is a detailed introduction.

Assemble.

(1) demould the solidified inner liner and head and cut them into the size specified in the design document.

(2) use the assembly ring to butt joint the inner liner and the head of the cylinder, adjust the assembly ring to the nominal diameter of - 30mm, insert the assembly ring into the inner liner of the cylinder, tighten the assembly ring to the nominal diameter of - 15mm, cover the lower head on the exposed part of the assembly ring, slowly tighten the assembly ring, and measure the circumference of the inner liner and the diameter of 3 points (uniform distribution) to meet the standard requirements.

(3) lay the outer reinforcement layer of butt joint, polish the joint area, and lay the outer joint from the inside to the outside step by step (increasing width), with the outer width not less than 250mm. After the overall reinforcement, the inner seam shall be bonded with resin lining and short cutting felt, and laid from the outside to the inside step by step (increasing width).

The upper and lower heads are formed and strengthened. The head is divided into inner lining layer and structural layer according to the structure.

(1) the forming process and raw materials of the inner liner of the head are the same as those of the inner liner of the cylinder. The spray gun is used for spray forming, with high resin content. The inner liner of the head is laid and deeply solidified.

(2) the structural layer of the head shall be laid, and the spray yarn and glass cloth shall be sprayed by the spray gun alternately. In the process of laying each single layer of glass cloth, a reasonable tension shall be applied, and a proper amount of overlap shall be applied between each other, and the combined pressing roller shall be used to repeatedly roll out the bubbles to ensure that the fiber is completely soaked. It is required that each reinforcement layer meet the resin content requirements of the design.


 

Product

FRP Container Series
FRP Pipe Series
Environmental Protection Equipment
FRP Cooling Tower Series
FRP Grid Series
FRP Sump Hood
FRP Septic Tank
FRP Anticorrosive Insulation
Wet Electrostatic Precipitator
FRP Chimney

Mobile QR code

Contact us

Made in China, Shengyang FRP


Tel: 0536-4971568

Fax: 0536-4832568

Q Q541725060

Manager: Yin Huibin

Mobile: 13583651568

Address: No. 388, FRP Industrial Park, 2km south of Anqiu toll station, Weifang, Shandong, China